Power supply LIPS-2-20 (LIPS 2-20; LIPS2-20; LIPSII-20; LIPSII 20; LIPSII-20; LIPSII20)
Source LIPS-2-20 - products intended to supply electronic circuits and devices stabilized DC voltage.
Output voltage - 0 - 20V.
Maximum load current: 2A.
In the block functions are implemented self-blocking output voltage exceeds the overcurrent or short-circuit in the load with light, connect and disconnect the load after setting the output voltage, getting bipolar output voltage.
Output terminals of the device LIPS-2-20, isolated from the hull, allowed ground plus or minus output voltage.
The instability of the output voltage at the output terminals LIPS-2-20 in the control range 3-35V when the voltage of ± 10% of nominal for any permissible current load does not exceed ± 0,05%. The instability of the output voltage at the output terminals in a control range 3V - 35V when the load current to 1A should not exceed ± 0,15%.
The temperature coefficient of output voltage Lips-2-20 in the control range 3B - 35B when the ambient temperature in the range 10 ° C - 35 ° C at a maximum permissible load current of 10 A does not exceed 0.1% C after warm-up time.
The drift of the output voltage is 8 hours after 20 minutes of heating does not exceed 0.5% when the output voltage 3B - 35B.
Power supply LIPS-2-20 provides a normal load voltage and current at 1 minute after the start, and the parameters of the output voltage within the rules after the time samoprogreva 20 minutes.
LIPS-2-20 provides protection against current overload. Protection is triggered when the load current exceeds more than 10A. The device LIPS-2-20, provides protection circuit overvoltage output with adjustable set trigger voltage range 5V - 35V. Error protection operation when the load current in the range 0-10A does not exceed 2C.
Switching on the instrument after protection from over-current and over-voltage is possible after the power is turned off LIPS-2-20, eliminating congestion.
Dielectric strength output circuits - 250V DC. Insulation strength of input circuits - 1000V AC RMS value.
Insulation resistance of these chains relative to the housing unit of at least 20MOm for normal conditions.
Continuous working time 8:00 to the time samoprogreva. Warm-up time 20 minutes.
The service life of LIPS-2-20 is at least 10 years of technical resources not less than 5000 hours.
Attention!Delivery of all instruments, which are listed on the site, is on the whole territory of the following countries: Russia, Ukraine, Belarus, Kazakhstan and other CIS countries.
According to Russia, there is an established system of delivery to cities: Moscow, St. Petersburg, Surgut, Nizhnevartovsk, Omsk, Perm, Ufa, Norilsk, Chelyabinsk, Novokuznetsk, Cherepovets, Almetyevsk, Volgograd, Lipetsk, Magnitogorsk, Togliatti, Kogalym Kstovo New Urengoy Nizhnekamsk, Nefteyugansk, Nizhny Tagil, Khanty-Mansiysk, Yekaterinburg, Samara, Kaliningrad, Nadym, Noyabrsk, Vyksa, Nizhny Novgorod, Kaluga, Novosibirsk, Rostov-on-Don, Upper Pyshma, Krasnoyarsk, Kazan, Naberezhnye Chelny, Murmansk, Vsevolozhsk Yaroslavl, Kemerovo, Ryazan, Saratov, Tula, Usinsk, Orenburg, Novotroitsk, Krasnodar, Ulyanovsk, Izhevsk, Irkutsk, Tyumen, Voronezh, Cheboksary, Neftekamsk, Novgorod, Tver, Astrakhan, Novomoskovsk, Tomsk, Prokopyevsk, Penza, Urai, Pervouralsk , Belgorod, Kursk, Taganrog, Vladimir, Neftegorsk, Kirov, Bryansk, Smolensk, Saransk, Ulan-Ude, Vladivostok, Vorkuta, Podolsk, Krasnogorsk, Novouralsk, Novorossiysk, Khabarovsk, Zheleznogorsk, Kostroma, Zelenogorsk, Tambov, Stavropol, Svetogorsk, Zhigulevsk , Arkhangelsk and other cities of the Russian Federation.
Ukraine has a well-established on the delivery system in the cities: Kiev, Kharkov, Dnepr (Dnepropetrovsk), Odessa, Donetsk, Lviv, Kiev, Nikolaev, Lugansk, Vinnitsa, Simferopol, Kherson, Poltava, Chernihiv, Cherkasy, Sumy, Zhytomyr, Kirovohrad, Khmelnytsky, Rivne, Chernivtsi, Ternopil, Ivano-Frankivsk, Lutsk, Uzhgorod and other cities of Ukraine.
On Belarus there organized system of delivery to cities: Minsk, Vitebsk, Mogilev, Gomel, Mozyr, Brest, Lida, Pinsk, Orsha, Polotsk, Grodno, Zhodino Molodechno and other cities of Belarus.
In Kazakhstan there is an established system of delivery to cities of Astana, Almaty, Ekibastuz, Pavlodar, Aktobe, Karaganda, Uralsk, Aktau, Atyrau, Arkalyk, Balkhash, Zhezkazgan Kokshetau Kostanai, Taraz, Shymkent, Kyzylorda, Lisakovsk, Shakhtinsk, Petropavlovsk, reader, Ore, Families, Taldykorgan, Temirtau, Ust-Kamenogorsk and other cities of Kazakhstan.
Ongoing delivery of devices to such countries: Azerbaijan (Baku), Armenia (Yerevan), Kyrgyzstan (Bishkek), Moldova (Chisinau), Tajikistan (Dushanbe), Turkmenistan (Ashgabat), Uzbekistan (Tashkent), Lithuania (Vilnius), Latvia (Riga ), Estonia (Tallinn), Georgia (Tbilisi).
LLC «Zapadpribor» - a huge selection of measuring equipment for the best value and quality. So you can buy inexpensive devices, we monitor competitors' prices and are always ready to offer a lower price. We only sell quality products at the best prices. On our site you can buy cheaply as the latest innovations and proven equipment from the best manufacturers.
The site includes a special offer «buy at the best price» - if other Internet resources in products presented on our site, the lower price, we will sell it to you even cheaper! Buyers also additional discount for leaving a review or photo of use of our products.
In the price list contains not the whole range of products offered. Prices of goods, not included in the price list can learn to contact the manager. Also, our managers You can get detailed information about how cheap and profitable to buy instrumentation wholesale and retail. Telephone and e-mail for advice on the purchase , delivery or receipt are shown on the description of the goods. We have the most qualified staff, quality equipment and the best price.
LLC «Zapadpribor» - the official manufacturer's dealer test equipment. Our goal - selling high quality goods with best price offer and service to our customers. Our company can not only sell you the necessary instrument, but also offer additional services to its calibration, repair and installation. That you have a pleasant experience when shopping on our site, we have provided special gifts guaranteed to the most popular products.
Plant «META» - is the most reliable manufacturer of equipment for inspection. Brake stand STM produced on this plant.
Manufacturer TM «Infrakar» - a manufacturer of multifunction devices gas analyzer and smoke meter.
If there is no site in the descriptive information you need on the device you can always turn to us for help. Our qualified managers will update for you on the technical characteristics of the device from its technical documentation: user manual, certificate, form, operating instructions, diagram. If necessary, we will take a photo of your device, or a device stand.
You can leave feedback on the unit purchased from us, the meter, the device, indicator, or product. Your review for your approval will be published on the site without contact information. Description of the instruments taken from the technical documentation or technical literature. Most pictures of products made directly by our experts prior to shipment of goods. In the description of the device provided the main technical characteristics of the instrument: nominal measuring range, accuracy class, scale, supply voltage, size (size), weight. If the site you see the discrepancy device name (model) specifications, photo or documents attached - let us know - you will get a useful gift with-selling device.
While the need to clarify the overall weight and size or the size of the individual meter you can in our service center. If you need our engineers will help you choose the most complete analog or a suitable replacement for the device you are interested. All counterparts and replacement will be tested in one of our laboratories with the full compliance to your requirements.
Our company carries out repairs and maintenance of measuring equipment in more than 75 different factories of the former Soviet Union and CIS. We also provide such metrological procedure: calibration, tare, graduated, testing of measuring instruments.
If you can make repairs to the device yourself, our engineers can provide you with a complete set of necessary technical documentation: circuit diagram TO, ER, FD, PS. We also have an extensive database of technical and metrological documents: technical specifications (TS), the terms of reference (TOR), GOST (DSTU), the industry standard (OST) test procedure, the method of certification, verification scheme for more than 3,500 types of measuring equipment from the manufacturer this equipment. From the site you can download all the necessary software (the software driver) is required for the product purchased.
We also have a library of legal documents that are related to our field of activity: the law, code, ordinance, decree, temporary position.
Upon request, each measuring device is provided metrological certification or verification. Our staff can represent your interests in such organizations as the metrological Rostest (Rosstandart), State Standard, Derzhspozhiv standard (Derzhspozhivstandart), TSLIT, OGMetr.
Sometimes customers can enter our company name wrong - for example, zapadprybor, zapadprylad, zapadprіbor, zapadprilad, zahіdpribor, zahіdprіbor, zahidpribor, zahidprilad, zahidprіbor, zahidprybor, zahidprylad. That's right - Zapadpribor or zahіdprilad.
LLC "Zapadpribor" is the supplier of ammeters, voltmeters, power meters, frequency meters, phase meters, shunts and other devices such manufacturers of measuring equipment, such as: PO " Elektrotochpribor " (M2044, M2051), Omsk, OAO "Instrument-Making Plant "Vibrator" (M1611, Ts1611), St. Petersburg, JSC "Krasnodar ZIP " (E365, E377, E378), LLC " ZIP Partner" (Ts301 , Ts302 , Ts300) and "ZIP" Yurimov"(M381, C33), Krasnodar, OAO "VZEP" ("Vitebsk factory of electrical appliances") (E8030, E8021), Vitebsk, OAO "Electropribor" (M42300, M42301, M42303, M42304, M42305, M42306), Cheboksary, JSC "Elektroizmeritel" (Ts4342, Ts4352, Ts4353 ) Zhitomir, PJSC "Uman factory "Megger" (F4102, F4103, F4104, M4100), Uman.