Equipment for maintenance checkup >> - the list of equipment for vehicle inspection >> diagnostic stands (LD-, TU- and others)
Tester slip wheels TU-3000 designed to control and receive the rectilinear motion of all axes of the car.
Also, this tester may be referred to: TU 3000, TU3000, ty-3000, ty 3000, ty3000.
Testers measure the magnitude of the slip, which occurs due to incorrect wheel alignment or suspension geometry changes in the exchange.
The device is TU-3000 consists of a slip pad, controller and PC. Playground slip - is measuring and unloading platforms installed at floor level in the basement.
Maximum axle load - 3000 kg.
Measuring range - ± 15 m / km.
Dimensions of the area - 800h460h50 mm.
Graduation indicator - ± 0,1 m / km.
Error - no more than ± 0,2 m / km.
Effort to move the slider platform from 0 to 0.1 mm - not more than 40 N.
Effort to move the slider to test the lateral sliding value of 5 m / km - not more than 80 N.
Weight Tester TU-3000 - 55 kg.
Measurements conducted slip during vehicle traveling at low speed (5.3 km / h) through the test platform, the TU-3000. Power moves the lid side effects connected to the carriages, which in turn act on the sensor. The controller converts the displacement sensor into an electrical signal which is transmitted to the PC.
Checking slip car wheels carried out by two operators - operator-driver and the operator PC.
The measurement results are displayed on the PC monitor, which is part of the brake tester.
TU-3000 testers slip may be operated in:
- Ambient temperature - from -30 ° C to +50 ° C;
- Atmospheric pressure - from 75.6 kPa to 106.7 kPa;
- Relative humidity at +25 ° C - up to 100%.