Customer: Car inspection station in Kirovograd.
Performers: engineer to connect and configure the hardware.
Activity type:
1. Installation and connection of brake tester STM-15000U.01.
2. Training.
3. Wireless connection to the Line of Control diagnostic devices.
4. Training staff to work with software line diagnostic monitoring.
Progress you can see in the photos below.
If you want to view more photos - just click on it.
Frame-lodgement for brake tester STM-15000U.01 already concreted.
For effective drainage of a brake tester set up the tree run-off type.
Control cabinet brake tester STM-15000U.01.
Power and signal cables will be supplied to the roller brake tester units STM.
Tester STM-15000U.01 before installing in-frame cradle.
To install the roller assemblies used by the crane.
Roller assemblies are installed.There is a disconnect circuits.
Align brake tester in the vertical plane by means of laboratory vaservagi.

Pay attention to the quality of the surface of the roller drum. Warranty coverage is for 12 years.
After alignment is welding clamps to the frame-lodgement.
Welding performed qualitatively evidenced by appearance of the joint.
The control cabinet without the front panel. There is a supply of food.
Connect power and signal cables to the right of the roller brake tester unit STM-15000U.01.
Ground connection to the body of the brake stand.
Brake stand ready to conduct diagnostic testing brake systems in motor vehicles.
For ergonomic use of force sensor on the brake pedal is used tensioning system with staples.
Tester STM-15000U.01 - the diagnosis of the first car.
To brake tester STM-15000U.01 gauge of the vehicle reaches about 3 meters. So here are held diagnostic cars and trucks, and mining machinery.
To measure the intensity and configuration headlamps photometer IPF-01. For the motion of the photometer provides use of a special way.
The appearance of the laboratory inspection. Tester STM-15000U.01 posted at the entrance to the laboratory.

STM-15000U.01 the diagnosis of the first car.
|
STM-15000U.01 frame-lodgement concreted.
|
STM-15000U.01 the tree run-off type.
|
STM-15000U.01 control cabinet brake tester.
|
STM-15000U.01 power and signal cables.
|
STM-15000U.01 tester before installing in-frame cradle.
|
STM-15000U.01 to install the roller assemblies used by the crane.
|
STM-15000U.01 a disconnect circuits.
|
STM-15000U.01 align brake tester in the vertical plane.
|
STM-15000U.01 the surface of the roller drum.
|
STM-15000U.01 welding clamps to the frame-lodgement.
|
STM-15000U.01 welding performed qualitatively.
|
STM-15000U.01 a supply of food.
|
STM-15000U.01 connect power and signal cables.
|
STM-15000U.01 ground connection to the body.
|
STM-15000U.01 ready to conduct diagnostic testing.
|
STM-15000U.0 tensioning system with staples.
|
STM-15000U.01 gauge of the vehicle reaches about 3 meters.
|
STM-15000U.01 to configuration headlamps photometer IPF-01.
|
STM-15000U.01 the appearance of the laboratory inspection.
|