Equipment for maintenance checkup >> - Our work on installation of equipment for inspection

Installation of the brake stand STM-15000U (15 tons load) in the Lviv region

Customer: Car service station in Lviv region.

Artists: engineer connection and set up equipment.

Type of work:

1. Installing and connecting the brake stand STM-15000U.

2. Training.

3. Connect wire line to control diagnostic devices.

4. Training personnel to work with the software line diagnostic monitoring.

    The course work you can see in the photos below. 
    If you want to view more photos - just click on it.  
  
    Roller units brake stand STM-15000U installed in the frame-bottom layers. The customer also has rails for a photometer IPF-01.

STM-15000U roller units brake stand.
 
    In the building where the present survey inspection pit.

STM-15000U inspection pit.
 
    After the adjustment of horizontal and vertical position of the brackets are welded to the frame-bottom layers. This roller assembly brake stand STM-15000U is movable in the vertical plane.
 
STM-15000U welded to the frame-bottom layers.
 
    Welding fire brace.
 
STM-15000U welding fire brace.
 
    Note the equal distance between the shell brake stand and angle bottom layers. This indicates the accuracy of position adjustment units.
 
STM-15000U distance between the shell brake stand and angle bottom layers.

    To facilitate the exit of cars from the rear clip holes between roller performed at 3 cm above the front. To hit the back of trailer used small apareli.  
 
STM-15000U small apareli to hit the back of trailer.

    Case management is used to supply power to the brake stand STM-15000U, and for receiving signals from sensors measured the weight, hit, slip.
 
STM-15000U case management.

    General view of the placement equipment brake stand STM-15000U.
 
STM-15000U general view of the placement equipment.

    The first car was diagnosed on the brake stand. A happy customer is holding back his satisfaction.
 
STM-15000U the first car was diagnosed.

    General view of the laboratory inspection. Repair is not yet fully completed.
 
STM-15000U general view of the laboratory inspection.

Photos: Installation of the brake stand STM-15000U (15 tons load) in the Lviv region

STM-15000U roller units brake stand.
STM-15000U roller units brake stand.
STM-15000U inspection pit.
STM-15000U inspection pit.
STM-15000U welded to the frame-bottom layers.
STM-15000U welded to the frame-bottom layers.
STM-15000U welding fire brace.
STM-15000U welding fire brace.
STM-15000U distance between the shell brake stand and angle bottom layers.
STM-15000U distance between the shell brake stand and angle bottom layers.
STM-15000U small apareli to hit the back of trailer.
STM-15000U small apareli to hit the back of trailer.
STM-15000U case management.
STM-15000U case management.
STM-15000U general view of the placement equipment.
STM-15000U general view of the placement equipment.
STM-15000U the first car was diagnosed.
STM-15000U the first car was diagnosed.
STM-15000U general view of the laboratory inspection.
STM-15000U general view of the laboratory inspection.