Customer: laboratory TI in the Odessa region.
Performers: engineer to connect the diagnostic equipment.
1.Installation and connection of brake tester STM-15000U.
Date of performance: August 2011.
Progress you can see in the photos below.
If you want to view more photos - just click on it.
Tester STM-15000U loaded on our stock in Lviv.
From brake testers will also be transported frame cradle. In which the future will be determined and fixed roller brake tester units.
When you load the frame-lodgement for brake tester STM-15000U forklift operator has demonstrated an enviable virtuosity.
The car is fully loaded and ready to deliver to the customer equipment.
Autoloader is already installed roller brake assemblies. Engineer summed up the signal and power cables.
Pay attention to the quality of the brake assembly brake tester series of STM. Powerful engine, the gearbox - in-house development of the plant, strong chains, and most importantly yourself brake rollers monolithic type. The warranty on the roller surface 12 years.
Control cabinet brake tester STM-15000U. There is power management, reception and conversion of signals from the brake tester, and control commands the brake stand.
For the data obtained in measuring the brake stand is accurate it should be put in the horizontal and vertical directions.
According to the norms of the GOST to check the backlash is necessary to use the steering swivel device.
Block switching of signals from sensors brake assemblies located in the left brake unit connects to it with the right cable unit.
The first clips are welded brake tester STM-15000U.
Fasteners brake tester have a structure providing blocking horizontal movement under the influence of brake tester heavy-duty trucks. At the same time the free movement in the vertical plane, which if necessary can be taken out of lodgement brake unit.
Pay attention to the surface of the rollers. Spikes monolithic type made with a solid roller milling of the workpiece. The warranty on the surface of roller 12 years.
That the operator could properly perform the vehicle measurement procedure for brake stand, light is used, which gives the management team.
The computer is installed and connected to the brake stand. Everything is ready for measurement.
The first car runs diagnostics on the brake stand STM-15000. Due to the spiral milling rollers are self-centering studs vehicle.
Photos: Installation of the brake stand for STM-15000U station TI in the Odessa region.