Customer: SRT in the Odessa region.
Performers: mounting Brigade (3 women).
1. Mounting frame for lodgement-brake tester STM-15000U.
2. Mounting frame for lodgement-brake tester STM-3500M.
3. Installation and connection of brake tester STM 15000U.
4. Installation and connection of brake tester STM-3500M.
5. Combining all the diagnostic equipment into a single system with LTK.
Date of performance: June 2011.
Features of these works was that the brake testers were at a considerable distance (23 and 28 meters) from the control cabinet.The customer signal cables fabricated by special order.
Progress you can see in the photos below.
If you want to view more photos - just click on it.
During loading operations used forklifts.
Brake Testers STM-15000U and STM-3500M loaded in the car.
Setting the frame-lodgement for brake tester STM-3500M.
General view of the room where it will be inspected vehicles.
The final stages of the concreting of the frame-lodgement for brake tester STM-15000U.
Exterior view of the future of the laboratory inspection. Hangar type room with a tunnel passing through.
Interior view of the laboratory, where will be installed equipment for inspection.
Operators of brake stands will be located in specially-designated area in the middle of the hangar.
Tester STM-15000U ready for installation.
Frame-cradle on the brake stand STM-3500M is fully assembled and ready to use. Concrete advocated more than a month.
Frame cradle on the brake stand STM-15000U ready for use. Soon it will be posted tester.
Supply cable to the brake stand going through the pipes.
To install the brake stands used forklifts.
Two roller assemblies of equipment tester STM-15000U installed and ready to connect.
Installation of the brake stand STM-3500M.
Tester STM-3500M is installed and ready to connect.
Installation and wiring of control cabinets brake stands. Before connecting for ease of installation of the cabinets removed the front panel.
Pedal to measure the force of pressure on the brake pedal.
Summing up the signal cables from the brake stands to computers. Note the presence of emergency stop buttons, brake stands.
Operators of brake stands to sit in a specially equipped for this area.
Control cabinets are installed and connected.
Computer for brake tester STM.
Pay attention to the quality of the coating roller brake tester. The warranty on the surface of rollers 12 years.
To confirm that the indicators on the tester STM-15000U being pushed another car.
When inspecting the car self-aligning. This occurs through the spiral milling the surface of the rollers.
Check the brake system on the car brake stand STM-3500M.
Joyful customer holding a flag in the background of our company's proven his car.
Photos: Installation and setup lodgements brake stand STM-15000U and STM-3500M for the newly built inspection station in the Odessa region