Customer: Car Service station in Kharkiv region.
Performers: engineer to connect and configure the hardware.
1. Installation and connection of brake tester STM-15000U.01.
Date of execution: in September 2011.
Progress you can see in the photos below.
If you want to view more photos - just click on it.
Load brake tester STM-15000U.01 our warehouse in Lviv.
Load second roller brake tester unit STM-15000U.01.
Unloading roller assemblies at the customer site. In the absence of a crane used an escalator.
Tester STM-15000U.01 can diagnose braking system of vehicles with axle load up to 18 tons.
Importation brake assemblies to customer premises.
Install the left wheel-brake assembly to the frame of the stand-lodgement.
Two roller assemblies installed in the frame-lodgement. Everything is ready for connection.
To align the brake tester in the horizontal and vertical planes using laboratory vaservaga.
Align the brake stand in a transverse position.
After the leveling roller units are weld metal clamps to lodgement.
Metal clamp is welded to the cradle.Note that the latch locks the movement of the stand only in the horizontal plane. Therefore, brake stand, if necessary, can be easily removed from the frame-lodgement.
Ground connection to the roller unit.
Divert water and mud from the wheels of cars in the wet season and in winter, a special decanter.
Installation of traffic lights.It is used to signal commands the brake stand.
Control cabinet brake tester STM-15000U.01. Since the stand is used a two-speed two times more starters. To demonstrate the front panel of the enclosure was removed.
Connecting the signal and power cables to the right roller assembly.
Connecting the signal and power cables to the left of the roller assembly.
Stand fully assembled and ready for the first test.
To measure the strength of pressure on the brake pedal uses a special sensor. For convenience, the sensor cable is cling to the rope stretched metal.
Room operator brake tester. The package brake tester series of STM is a computer with a licensed operating system Windows.
The diagnosis of the first car to brake stand STM-15000U.01.
KrAZ vehicles are also easily diagnosed on the brake stand STM-15000U.01.
The appearance of the diagnostic laboratory. Garage type room.
Photos: Install two speed brake tester STM-15000U.01 in the Kharkiv region.