Equipment for maintenance checkup >> - the list of equipment for vehicle inspection >> equipment for inspection and auto service of the plant "GARO" >> brake testers STS
Roll-purpose tester BDE 3504 SC UW1 SmG 13t (Cartec, Italy) is used to monitor the effectiveness of the service and parking brake systems of cars and trucks, buses and trucks with axle loads up to 13 tons.
Also this Brake Tester can be called: BDE3504 SCUW1 SmG 13t, BDE-3504 SC UW1 SmG 13t, BDE3504 SCUW1 SmG13t, BDE-3504-SC-UW1-SmG 13t, BDE 3504 SC UW1 SMG 13T.
Test width - 830-2830 mm.
Floor standing unit rolls.
Brake stands BDE 3504 SC UW1 SmG 13t measure:
- Axle load;
- The braking force at each wheel;
- The control force;
- Air pressure in the pneumatic-hydraulic brake actuator ATS;
- Specific braking force;
- The relative difference between the axis of the wheel brake force;
- Asynchronous time delay brake actuator units train.
Maximum axle - 13,000 lbs.
Measuring force exerted on the control of brake system - up to 1000 N.
Meter braking force (for one wheel) - 0-30 kN.
Test width min. - Max. - 830-2830 mm.
Measuring range air to air drive - 0-1 MPa.
The initial braking speed on the stand BDE 3504 SC UW1 SmG 13t - 2,8 km / h
The coefficient of adhesion with the rollers dry. / Humidity. - 0.9 / 0.5.
Roller diameter - 205 mm.
Length of commercials - 1000 mm.
Rise of the rear rollers - 30 mm.
Motor power - 2x9, 2 kW.
The maximum power measured maximum brake force for 10 - 20 kW.
Dimensions of the stand BDE 3504 SC UW1 SmG 13t (each unit) - 1920x700x260 mm.
Weight - 2x300 kg.
dimensions - 2000x1000x190 mm;
weight - 90 kg.
Power supply voltage - 380 V.
Power frequency - 50 Hz.
Power consumption - 19 kW.
Operating Temperature - 0 ° C to +70 ° C.
Scope of supply:
1. Block steel rollers for conventional and studded tires (cover SmG) - 2 pcs.
2. Communication cabinet with analog indicators - 1 pc.
3. Power and communication cables - 1 set.
4. Strain gauge load cell - 1 pc.
5. Zaezdnyh inclined ladders and sezdnye - 4 pcs.
6. The control system based on the PC - 1 pc.
7. Cable to connect the PC and the communication closet - 1 pc.
8. The weighing system of axle load - 1 set.
9. Module 4WD - 1 pc.
10. Infrared remote control - 1 pc.
11. PD 7 - sensor for measuring the force on the brake pedal - 1 set.
12. Air Pressure Sensor LD 5 - 1 piece.
13. The calibration device core - 1 pc.
14. Adapter kit for calibration device - 1 pc.
Photos: BDE 3504 SC UW1 SmG 13t